Carbon Monoxide Analyzer with Flue Probe

The TPI 707 combustion analyzer uses a state of the art electrochemical sensor. This sensor technology provides the longest lasting, most accurate and reliable means for performing tests. The sensor in your analyzer will need to be replaced periodically and calibration is recommended once every year. The 707 will remind you when calibration is due by flashing “CAL DUE Err” for three seconds at start up if the date of calibration is one year or older. The following guidelines will help prevent damage to your sensor: Always use the mini pump filter when performing tests. Always periodically check and replace the mini pump filter as needed. Always make sure the in-line filter / water trap is installed properly. Always periodically check and replace the in-line filter as needed. Always remove water or condensation from the inside of the in-line filter / water trap assembly prior to performing tests. Always use the optional oil filter (p/n A772) when performing tests on oil burning equipment. Never over saturate your sensors by performing tests on equipment with gas levels beyond the capability of you analyzer. - • Clear and fast response with advance pump driven technology. • Peak Hold to capture peak CO reading. • Instrument recycles and will not shut off if 15ppm CO is present, increasing safety. • Store Button allows you to save up to eight readings and then print using the IR port and optional A740 printer. • 1 ppm sensitivity. • Measures up to 10,000ppm. • Push on fittings are fast and easy to use. • Large easy to read backlit display. • Advanced electrochemical sensor is field replaceable and calibrateable. • Protective rubber boot and soft carrying case with shoulder strap is included - • Clear and fast response with advance pump driven technology. • Peak Hold to capture peak CO reading. • Instrument recycles and will not shut off if 1 0 ppm CO is present, increasing safety. • Store Button allows you to save up to eight readings and then print using the IR port and optional A740 printer. • 1 ppm sensitivity. • Measures up to 10,000ppm. • Push on fittings are fast and easy to use. • Large easy to read backlit display. • Protective rubber boot and soft carrying case with shoulder strap is included